Storage heaters require a separate circuit for each heater. This is because, unlike direct acting heaters which are switched on and off as required, storage heaters are all switched on together during the 8-hour period. They cannot therefore be supplied from a ring circuit which is based on diversity of use of various appliances; each heater must have its own circuit.
The circuit for a storage radiator consists of 2.5 mm2 2-core and earth PVC sheathed cable. The cable starts at a 20 A fuseway in the time-controlled consumer unit and terminates at a 20 A double-pole switch fixed next to the storage radiator and connected to it with 3-core flexible cord via the cord outlet of the 20 A switch.
There are circumstances where two storage heaters are supplied from a single 30 A circuit. Each heater must then be supplied through a fused outlet which is a switched 13 A fused connection unit. Such an arrangement would be limited to two heaters having loadings of not more than 3 kW to prevent possible overheating of the fused connection unit.
The circuits supplying the heater will be the same as those supplying storage radiators, but it is also necessary to provide a circuit for the fan.
As a fan takes very little current, small size cable as used for lighting circuits is suitable. The fan can, in fact, be supplied from a lighting circuit but rather than introduce a lighting circuit into a heating circuit it is better to feed the fan from a fused spur cable off the ring circuit. Where there is more than one storage fan heater all fans can be served by the one fused spur.
Both the heater and the fan require an isolating switch fixed near the heater to terminate the circuit cables and as a flex connection for the heater unit. As this heater will be supplied by two circuits, regulations require that the two switches are mechanically linked so that one cannot be switched off without the other.
To meet these requirements there is available a 25 A twin switch with or without pilot lights and with two cord outlets; one marked ‘Fan‘ the other marked ‘Heater‘.
Heat output of a fan heater can be automatically controlled by introducing a room thermostat and/or timeswitch into the fan circuit, but generally it is sufficient to control the fan manually.
Electrically warmed floors are applicable only to new houses, bungalows and flats during construction. If you move into a dwelling where this type of heating is installed, seek advice from the electricity board particularly regarding off-peak tariffs and running costs.
This is a system which directs warm air through a ducts system. It must be installed as a house is being built or being reconstructed under a home improvement scheme. The system needs a 45 A circuit from a 45 A fuseway to a control unit fixed near the unit.
This system is comparatively new. Before embarking on an installation it is advisable to discuss the project with the electricity board.
Possibly related posts: (automatically generated)
Storage Heater Circuits
If the robot Create contains an robot rechargeable battery, the Home Base will serve as a charging station as well. … Eagle Creek Dual Wattage International Converter
For over 86 years, Sea Gull Lighting has grown to an established leader in the electrical and lighting industry. … Robert Abbey Lighting
use thankless water heaters are designer to provide an endless supply of hot water for kitchen, bathroom, washing sinks. … Space Heaters
Affordable MSW inverters are the most popular type, and work well with common appliances you are likely to use. … Discount Kitchen Appliance
Consumers can cut costs quickly by switching from incandescent bulbs or fixtures to compact fluorescents. … Fan Heaters
You can, monitor four wireless XCam2 cameras from any location (such as your work PC) with an Internet connection. … Wireless Remotes
Integrating and Semi Integrated Dishwashers Built in dishwashers are installed underneath your kitchen counter so it is important to make sure you have enough space before making your purchase. … Gas Heaters