This failure is normally attributed to a loss of electrical power or an electrical overload.
To find the cause of the problem, move the dryer out from the wall and unplug the dryer power cord from dryer wall receptacle. Make a voltage check with the volt/ohmmeter to determine if there is electrical power available to the dryer receptacle or to the dryer power cord.
To avoid incorrect readings when using the volt/ohmmeter, always “zero” the ohmmeter before making continuity checks. See operating instructions that came with your volt/ohmmeter. Read the rest of this entry »
Unplug the power cord or gas supply before servicing the clothes dryer. Move clothes dryer out from the wall. Exercise care when moving the dryer from its original position because the dryer legs can easily tear holes in your floor.
Remove screws to dryer top. Lift the top of the dryer by inserting a flat-blade screwdriver between the cabinet and the top of the dryer. Remove the screws that secure door switch to dryer front panel and discard the door switch. Read the rest of this entry »
An obvious failure symptom is when you select a drying cycle and attempt to start the dryer, but it does not run. To find the cause of the problem, move the dryer out from its position and unplug the power cord.
If line voltage is indicated on the volt/- ohmmeter, check the dryer power cord as possible cause of the problem.
To avoid any incorrect readings when using the volt/ohmmeter, always “zero” the ohmmeter before making continuity checks on components. Read the rest of this entry »
The brush roll is supported on bearings at each end so the barrel rotates freely. Types of bearings, barrels and brushes differ from model to model as well as between manufacturers. Some manufacturers supply individual parts for the brush roll, such as brush strips, bearings and barrel; others supply only complete assemblies. The brush roll on some models may have removable brush strips, whereas others may be a solid brush roll of wood or plastic with fixed brushes. A small selection is shown here to highlight the differences. Read the rest of this entry »
Cord rewinds are now found on all types of cleaners, from simple hand-operated versions to the fully automatic rewind at the touch of a button. Many auto cord rewind systems use open coil springs and great care should be exercised if a stripdown of these systems is called for. Protection for the eyes is recommended. Goggles afford adequate protection from the spring itself or any item that it may throw out in the event of its slipping from position.
Operation of the cord rewind relies on tensioning of the rewind spring as the cord is pulled out for use. A small brake pad prevents the immediate return of the spring and cord drum to its original position. Read the rest of this entry »
