If the washer is not spinning, the next check is of the washer control magnet. Washers use a control magnet, an electrical-mechanical component, to enable the gearcase to shift into the spin cycle. You can easily check the control magnet by using the volt/ohmmeter set on the RX-10 scale. With the volt/ohmmeter on RX-10 scale, connect the probes to both terminals of the control magnet. NOTE: When checking a suspected faulty control magnet, remove the wires from the washer wiring harness to avoid an inaccurate reading. Read the rest of this entry »
Specific failure symptoms include: 1) Washer fills with water, and motor starts to run, but the washer agitator does not turn in either a clockwise or counterclockwise direction, or 2) At end of cycle, clothes are gritty and soapy with water.
To find the cause of the problem, first check to make sure that the washer power cord has not worked loose in the wall socket. Read the rest of this entry »
