A final condition that could cause weak pump-out is a loose drive belt that doesn’t rotate the water pump. A sure and quick check that involves no hand tools is to turn the timer knob to a cycle where there is a motor function such as spin or agitate. With the timer dial on spin cycle, the washer should begin to spin the clothes. If you hear the sound of the motor running, but the washer tub is not moving or attempting to spin the clothes, then it can be assumed that the washer drive belt is slipping on the drive motor pulley or the belt is broken. Read the rest of this entry »
If the washer is not spinning, the next check is of the washer control magnet. Washers use a control magnet, an electrical-mechanical component, to enable the gearcase to shift into the spin cycle. You can easily check the control magnet by using the volt/ohmmeter set on the RX-10 scale. With the volt/ohmmeter on RX-10 scale, connect the probes to both terminals of the control magnet. NOTE: When checking a suspected faulty control magnet, remove the wires from the washer wiring harness to avoid an inaccurate reading. Read the rest of this entry »
