When the solenoid is energized, the plunger is pulled upward by magnetic force of the solenoid coil, and the pin travels back and forth in the upper slot of the spin cam bar. This action pulls the spin cam bar backward from the basket clutch shaft, which allows the bar to slide downward toward the clutch lining. Read the rest of this entry »
Although the homeowner will probably never do a major teardown of a washer gearcase, it is worthwhile to understand its function. The gear train of the automatic washer consists of a sector gear, connecting rod or possibly the rack and pinion gear type. In this type drive, the pinion gear drives a larger main - drive gear. A connecting rod is attached to both ends of the main - drive gear and the sector gear, which pivots on a stud through an approximate 180 - degree arc. A more common type is the sector gear. This gear meshes with the agitator gear to accomplish the washer oscillation. Read the rest of this entry »
A final condition that could cause weak pump-out is a loose drive belt that doesn’t rotate the water pump. A sure and quick check that involves no hand tools is to turn the timer knob to a cycle where there is a motor function such as spin or agitate. With the timer dial on spin cycle, the washer should begin to spin the clothes. If you hear the sound of the motor running, but the washer tub is not moving or attempting to spin the clothes, then it can be assumed that the washer drive belt is slipping on the drive motor pulley or the belt is broken. Read the rest of this entry »
If the washer is not spinning, the next check is of the washer control magnet. Washers use a control magnet, an electrical-mechanical component, to enable the gearcase to shift into the spin cycle. You can easily check the control magnet by using the volt/ohmmeter set on the RX-10 scale. With the volt/ohmmeter on RX-10 scale, connect the probes to both terminals of the control magnet. NOTE: When checking a suspected faulty control magnet, remove the wires from the washer wiring harness to avoid an inaccurate reading. Read the rest of this entry »
Specific failure symptoms include: 1) Washer advances through the cycle but leaves water in the tub, or 2) The washer pumps all of the water out of the tub but clothes are wet at end of the cycle.
Check to be sure the washer lid is securely closed. Most automatic washers are designed to shut OFF if the washer lid is in the “up” position. This is a safety feature designed to prevent injury if the lid is opened while the washer is running and spinning.
Check to make sure that the washer power cord has not worked loose in the wall receptacle. A faulty connection could be the cause of washer failure. Read the rest of this entry »
