If the timer contact terminals show continuity and you find no voltage at the temperature selector switch, then you must make a continuity check for burned or broken wires from the timer assembly to the temperature selector switch. With the volt/ohmmeter dial set on the RX-1 scale, disconnect one wire from the terminal of the selector switch and attach a probe. Touch the remaining probe to the other end of same wire. If the wire you are checking is good, continuity (0 ohms) will be measured on the volt/ohmmeter. Read the rest of this entry »
Next, check the dryer cycling thermostats as the possible cause for no heat in the dryer. The types of thermostats most commonly used in dryers (gas or electric), are the bimetal fixedand adjustable thermostats. Their primary function is to break the circuit to the gas main burner or the heating element when a certain temperature has been attained in the dryer drum. You can easily check these thermostats by removing one lead from the suspected thermostat. Set the volt/ohmmeter on the RX-1 scale. Place one probe of the volt/- ohmmeter on each terminal of the thermostat. You should see a continuity reading on the volt/- ohmmeter scale of approximately 0 ohms, or full- meter deflection. If the thermostat does not show continuity, replace the defective thermostat to restore the dryer to proper operating order. Read the rest of this entry »
Unplug the Fridge power cord before servicing the Fridge. Move the Fridge out from the wall. Use extreme care when moving the Fridge, because the Fridge legs can easily damage the floor.
Open the Fridge door and locate the control console in the back of the Fridge cabinet. Remove the screws that secure the console cover. Remove the thermostat bracket. NOTE: Before removing the defrost timer from the Fridge cabinet, mark the wires, so they can be replaced correctly on the replacement part. Next, remove the screws that secure the defrost timer to the Fridge cabinet. Next, remove wiring harness and remove defrost timer. Read the rest of this entry »
Turn OFF the electricity at the circuit breaker panelbefore servicing the dishwasher. Exercise care when moving the dishwasher from its space. The leveling legs can easily damage the floor.
Turn OFF the electricity at the circuit breaker panel. Remove the screws that secure the lower panel to the dishwasher cabinet. Disconnect the drive motor connector from the harness wiring. Remove the hose clamp from drain hose that is secured to drive motor base coupling. Remove drain hose from coupling. NOTE: When removing drain hose, place a small pan or towel under the motor base coupling. It is possible that when hose is removed water could spill onto the floor. Read the rest of this entry »
The automatic dishwasher starts the cycle once the homeowner has placed the dishes in the dishwasher and the timer is pushed in or pulled out to ON. With the unit ON, electricity flows through the timer contacts to the water inlet valve solenoid. As the solenoid opens, hot water flows through the inlet valve, the inlet hose, and then into the dishwasher tub cavity. Read the rest of this entry »
