Some fluorescent fittings have no starter switch(s) for the tubes. Instead there is S transformer to provide the prewarming and the tube itself has a metal stripe running throughout its length from one lamp cap to the other. The lamp caps are earthed at the lampholders.
This assists in the starting of the electron flow and, as there is no starter to operate, the lamp strikes without the characteristic delay of the switch-start type.
A fluorescent tube has an expected life of 5000 to 7000 light hours or up to seven times that of an electric light bulb. Read the rest of this entry »
Plain and twisted candle lamps are made in 25 W, 40 W and 60 W sizes and in pearl, plain, amber and silvered colours. They are made in be (bayonet cap) and sbc (small bayonet cap) versions.
These are used for wall lights and for period pendant fittings.
These are sometimes called ’strip lights‘ and are non-fluorescent, being tungsten filament lamps. There are two versions, one type is commonly used for applications in the home, and the second type is known as architectural lamps‘. Read the rest of this entry »
The amount of light given out or produced by an electric lamp — bulb, striplight or fluorescent tube — depends on the type of lamp and its wattage. The light produced is measured in lumens and a bulb or tube of a given wattage produces an average output of so many lumens. This will continue throughout most of its life.
Equally important is the number of lumens produced for each watt consumed, so it is usual to say, when comparing types, that a bulb or tube produces so many lumens per watt. The more the lumens per watt, the higher the efficiency of the lamp. Read the rest of this entry »
Table lamps, floor standards, bedside lights and other portable lights can have dimmer control using any one of three methods. One method is a dimmer socket adaptor which plugs into the standard 13 A socket-outlet. This unit has two 2-pin sockets and is especially suitable for controlling two bedside lamps in a twin-bedded or a double-bedded room. The control knob on the adaptor dims both lamps at the same light intensity; they cannot be controlled independently.
Another method uses a line-cord dimmer which is wired into the flex of the lamp. The dimmer can be a standard wall type mounted on a plastic box and placed on the arm of the chair, table, desk, or any other chosen position. Alternatively, it can be a mini-dimmer switch resembling a torpedo table lamp switch. This type is especially suitable for the individual control of bedside lamps. Read the rest of this entry »
