A fused clock connector is a small non- switched fused outlet designed expressly for supplying a mains electric clock.
The unit is in two sections: a fixed base which is connected to the fixed circuit wiring, and another section in.the form of a flat pin plug which plugs into sockets in the base. The plug section carries the flex of the clock and contains the fuse. The plug is secured in the base by a retaining screw. This prevents the plug being pulled out accidentally and stopping the clock. Read the rest of this entry »
Specific failure symptoms include: 1) The dishwasher won’t complete the dishwasher cycle. 2) The dishwasher has a burning smell during the cycle.
Check the dishwasher wiring for a possible loose connection where it connects to the house wiring.
Check for a circuit breaker in the circuit breaker panel that is defective.
Check the dishwasher timer assembly for erratic operation. If the dishwasher suddenly started when the timer dial is pushed to the ON-OFF position, the timer assembly ON-OFF contacts are defective internally. You will have to replace the timer assembly in order for the dishwasher to program through the cycle properly. Read the rest of this entry »
Specific failure symptoms include: 1) When the dishwasher is turned ON, nothing happens. 2) When the dishwasher is turned ON a “buzzing” sound is heard.
To find the cause of this problem, first check to be sure the electricity is turned ON at the circuit breaker panel. Next, check to see that the dishwasher timer knob is pushed in or pulled out to the ON position when selecting a cycle. Read the rest of this entry »
Formerly imperial ratings were used for fuses and circuit breakers, but the international Renard ratings have now been added and will supersede them.
Fuse manufacturers are still using the imperial sizes while circuit breaker manufacturers have mostly changed to the new ratings. An equivalence chart is shown above.
The miniature circuit breaker (MCB) is now widely used and overcomes all the problems associated with ordinary fuses. It is a small, sophisticated unit affording a much higher level of protection than an ordinary fuse. It is tamper-proof and the unit involved is easily identified when one has tripped (the switch moves to the ‘off’ position). Most importantly, MCBs cannot be reset if the fault still exists; this eliminates the foolish and highly dangerous practice of putting in the wrong fuse wire or cartridge just to get things ‘conveniently’ working again for the time being. Read the rest of this entry »
A basic understanding of electricity is essential, even for those who do not intend to carry out any repairs or servicing of appliances. Ignorance is no protection against your own or someone else’s errors and oversights, whether with repairs, servicing or installation.
Power is supplied to an electricity substation at a very high voltage — 400,000 volts — in three-phase form. There it is converted, via a transformer, to 230 volt single-phase for distribution to our homes. In normal circumstances, current flows from the live supply of the substation’s transformer, through the electrical appliances used in the house and back via the neutral conductor (cable) to the substation transformer’s neutral pole (a closed loop). Read the rest of this entry »
