A final condition that could cause weak pump-out is a loose drive belt that doesn’t rotate the water pump. A sure and quick check that involves no hand tools is to turn the timer knob to a cycle where there is a motor function such as spin or agitate. With the timer dial on spin cycle, the washer should begin to spin the clothes. If you hear the sound of the motor running, but the washer tub is not moving or attempting to spin the clothes, then it can be assumed that the washer drive belt is slipping on the drive motor pulley or the belt is broken. Read the rest of this entry »
Unplug the Fridge power cord before servicing the Fridge. Move the Fridge out from the wall. Use extreme care when moving the Fridge, because the Fridge legs can easily damage the floor.
Open the Fridge door and locate the control console in the back of the Fridge cabinet. Remove the screws that secure the console cover. Remove the thermostat bracket. NOTE: Before removing the defrost timer from the Fridge cabinet, mark the wires, so they can be replaced correctly on the replacement part. Next, remove the screws that secure the defrost timer to the Fridge cabinet. Next, remove wiring harness and remove defrost timer. Read the rest of this entry »
Unplug the fridge power cord before servicing the fridge. Move the fridge out from the wall. Use extreme care when moving the fridge, because the fridge legs can tear or damage the floor.
Using hand tools, remove the screws on all four sides of the fridge or freezer doors so that you can remove and discard the defective gasket(s). Before removing the old gasket, note carefully how the gasket is installed, because the replacement gasket has to be installed in the same position as the defective gasket that is removed. Before installing the replacement gasket, heat the rubber with a home hair dryer set on low heat. This will make the rubber more flexible,’ and easier to install on the fridge or freezer door. Install the replacement door gasket by mounting the lip of the gasket under the retainer plate. Read the rest of this entry »
Unplug the Fridge power cord before servicing the Fridge. Move the Fridge out from the wall. Use care when moving the Fridge, because the metal feet can tear or damage the floor.
Open the freezer door and remove the plastic breaker strips at the front of freezer section. NOTE: When removing plastic breaker strips, heat them with a low- wattage (40-60) light bulb for 5 to 7 minutes. Heat will make the plastic more pliable and less susceptible to breakage. Read the rest of this entry »
Specific failure symptoms include: 1) Frost build-up on back wall in freezer section of Fridge. 2) Fridge ice maker not making ice. 3) Food not remaining at the desired temperature in both the Fridge and freezer sections.
When the Fridge starts to build up frost in the freezer section, you can assume that something is preventing the Fridge from going into the defrost cycle. You will have to check the components of the defrost circuit. Move the Fridge out from the wall and unplug the Fridge power cord. Check the components in the order listed below. Read the rest of this entry »
Turn OFF the electricity at the circuit breaker panelbefore servicing the dishwasher. Exercise care when moving the dishwasher from its space. The leveling legs can easily damage the floor.
Turn OFF the electricity at the circuit breaker panel. Remove the screws that secure the lower panel to the dishwasher cabinet. Disconnect the drive motor connector from the harness wiring. Remove the hose clamp from drain hose that is secured to drive motor base coupling. Remove drain hose from coupling. NOTE: When removing drain hose, place a small pan or towel under the motor base coupling. It is possible that when hose is removed water could spill onto the floor. Read the rest of this entry »
