The water supply that is controlled by a water inlet valve enters the mold cavity of the compact icemaker. The water then freezes in the icemaker mold. An electric heater thaws the frozen ice crescents so that they can be ejected from the mold. An electric motor then drives an ejector blade through a cam assembly, which frees the released crescents. The crescents revolve in a clockwise rotation and tumble into the ice storage bin. Read the rest of this entry »
Move the refrigerator out from the wall. Unplug the refrigerator power cord, and turn OFF the water supply to the icemaker.
Using hand tools, remove screws and discard the defective water supply valve. When installing a water supply valve on the water heater, install only on the cold-water side of the water heater. Read the rest of this entry »
Next in line after the water supply valve is the water inlet valve, usually located at the back of the machine near the bottom. The role of the water inlet valve is to release supply water from the supply line so that it can enter the icemaker mold cavity. However, the valve’s internal components can eventually become worn out from the corrosive properties and algae in the water, and fail to supply water to the mold cavity. Check the water inlet valve to see if it is electrically releasing the water on command to the mold cavity. Read the rest of this entry »
Specific failure symptoms include either: 1) Refrigerator temperature too warm to make ice. 2) No water getting to icemaker mold. 3) Icemaker not ejecting the frozen ice.
For a compact icemaker to operate properly, the refrigerator freezer compartment must be maintained at 10 degrees F or lower. The design of the icemaker is such that the icemaker will not eject the ice until it is frozen hard. Read the rest of this entry »
Socket-outlets situated off the main route of the cable do not have to be connected to the actual ring cable. Instead they are usually supplied from spur cables branching off the ring. These spurs are wired in the same size cable as that used for the ring.
Fixed appliances which may be connected to a ring circuit include skirting heaters, wall heaters, small water heaters and any non-portable electrical appliances having individual loadings of not more than 3000 W(13 A approx.). Read the rest of this entry »
Specific symptoms include: Little or no water enters the dishwasher tub cavity. To find the cause, first check to be sure the water supply is ON.
To avoid incorrect readings when using the volt/ohmmeter, always “zero” the ohmmeter before making any continuity checks on dishwasher components. See operating instructions that came with your volt/ohmmeter.
When making continuity checks with the volt/ohmmeter, always turn the electricity OFF at the circuit breaker panel. Live voltage checks will damage the meter movement. Read the rest of this entry »
A basic understanding of electricity is essential, even for those who do not intend to carry out any repairs or servicing of appliances. Ignorance is no protection against your own or someone else’s errors and oversights, whether with repairs, servicing or installation.
Power is supplied to an electricity substation at a very high voltage — 400,000 volts — in three-phase form. There it is converted, via a transformer, to 230 volt single-phase for distribution to our homes. In normal circumstances, current flows from the live supply of the substation’s transformer, through the electrical appliances used in the house and back via the neutral conductor (cable) to the substation transformer’s neutral pole (a closed loop). Read the rest of this entry »
The aim of this manual has been to assist in the D-I-Y repair of your household appliances. I hope that you will now not only possess a greater understanding of how your appliances work, but also the knowledge to prevent many faults from occurring. Above all, I hope that armed with this information, you will feel confident enough to tackle most of the faults that may arise from time to time.
All this knowledge and new-found confidence will be wasted, however, if you cannot locate the parts that you require to complete the repair.
This would once have been somewhat of a problem, but in recent years the availability of spares has increased. This is for several reasons. Read the rest of this entry »
