Specific failure symptoms include: 1) The washer won’t complete the wash or spin cycle. 2) The washer has a burning smell during the wash and spin cycle. 3) The washer leaves water in the tub at the end of the cycle.
Check the washer power cord for a possible loose connection at the wall plug receptacle.
Check to see if the wall receptacle is defective or has burned or oxidized contacts. If so, the repair should be made by a licensed electrician. Read the rest of this entry »
Specific failure symptoms include: 1) Dishwasher has a full tub of water at the end of the cycle. 2) Dishwasher only partially drains and leaves water in tub at end of cycle.
Remove the lower panel. Locate the pump drain hose and see if a kink in the hose is evident. If so, remove the kink and check the dishwasher for proper operation. If the dishwasher now pumps the water out, you found the problem — a kinked drain hose. If little or no water is being pumped out, the problem is in the dishwasher pump assembly. Read the rest of this entry »
Specific failure symptoms include: 1) The dishwasher won’t complete the dishwasher cycle. 2) The dishwasher has a burning smell during the cycle.
Check the dishwasher wiring for a possible loose connection where it connects to the house wiring.
Check for a circuit breaker in the circuit breaker panel that is defective.
Check the dishwasher timer assembly for erratic operation. If the dishwasher suddenly started when the timer dial is pushed to the ON-OFF position, the timer assembly ON-OFF contacts are defective internally. You will have to replace the timer assembly in order for the dishwasher to program through the cycle properly. Read the rest of this entry »
Specific symptoms include: Little or no water enters the dishwasher tub cavity. To find the cause, first check to be sure the water supply is ON.
To avoid incorrect readings when using the volt/ohmmeter, always “zero” the ohmmeter before making any continuity checks on dishwasher components. See operating instructions that came with your volt/ohmmeter.
When making continuity checks with the volt/ohmmeter, always turn the electricity OFF at the circuit breaker panel. Live voltage checks will damage the meter movement. Read the rest of this entry »
