The water supply that is controlled by a water inlet valve enters the mold cavity of the compact icemaker. The water then freezes in the icemaker mold. An electric heater thaws the frozen ice crescents so that they can be ejected from the mold. An electric motor then drives an ejector blade through a cam assembly, which frees the released crescents. The crescents revolve in a clockwise rotation and tumble into the ice storage bin. Read the rest of this entry »
Move the refrigerator out from the wall. Unplug the refrigerator power cord, and turn OFF the water supply to the icemaker.
Using hand tools, remove screws and discard the defective water supply valve. When installing a water supply valve on the water heater, install only on the cold-water side of the water heater. Read the rest of this entry »
Specific failure symptoms include either: 1) Refrigerator temperature too warm to make ice. 2) No water getting to icemaker mold. 3) Icemaker not ejecting the frozen ice.
For a compact icemaker to operate properly, the refrigerator freezer compartment must be maintained at 10 degrees F or lower. The design of the icemaker is such that the icemaker will not eject the ice until it is frozen hard. Read the rest of this entry »
Specific symptoms include: Little or no water enters the dishwasher tub cavity. To find the cause, first check to be sure the water supply is ON.
To avoid incorrect readings when using the volt/ohmmeter, always “zero” the ohmmeter before making any continuity checks on dishwasher components. See operating instructions that came with your volt/ohmmeter.
When making continuity checks with the volt/ohmmeter, always turn the electricity OFF at the circuit breaker panel. Live voltage checks will damage the meter movement. Read the rest of this entry »
