The components of a typical household refrigerator are described below:
The heart of the refrigerator system is the compressor. It is made up of a pump and an electric motor and is contained in a sealed dome through which the refrigerant travels.
The starting relayis an electromechanical switch used to start the compressor motor. As electricity flows, the starting relay energizes the start winding of the refrigerator compressor motor until the motor is almost up to speed. At this point, the relay breaks the electrical circuit to the start winding and the compressor motor continues to run on its run (or motor) winding. Read the rest of this entry »
There are three types of failures that are associated with the Fridge start capacitor. These failures are a defective capacitor. an open filament capacitor, and a grounded capacitor. You can check each of the above failures with the volt/ohmmeter. First, unplug the Fridge power cord. Using hand tools, remove the screws that secure the Fridge back and remove the starting capacitor from the compressor starting package. Look for traces of oil on or around the capacitor. If oil is present, the capacitor is defective.
CAUTION: A charged capacitor is extremely dangerous. A capacitor that has been removed from the compressor starting package will hold a charge indefinitely, even when not in use. If you touch the terminals of a charged capacitor, the built-up voltage could give a high-voltage shock that could be fatal. A flat-blade screwdriver across the terminals should be used to discharge a capacitor. Read the rest of this entry »
Specific failure symptoms include: 1) Dishwasher has a full tub of water at the end of the cycle. 2) Dishwasher only partially drains and leaves water in tub at end of cycle.
Remove the lower panel. Locate the pump drain hose and see if a kink in the hose is evident. If so, remove the kink and check the dishwasher for proper operation. If the dishwasher now pumps the water out, you found the problem — a kinked drain hose. If little or no water is being pumped out, the problem is in the dishwasher pump assembly. Read the rest of this entry »
Capacitors used for motor starting may have metal or plastic outer casings with an insulated top with two terminals. Internally the two terminals are connected to two sheets of metal foil with an insulator between. This package of large surface area is rolled into a cylinder which fits into the shell of the capacitor. As the voltage supplied to one terminal is alternating (at 50 times per second), so does the polarity of its connected foil. An opposite movement of electrons is induced in the other foil, even though they are insulated electrically. This causes a delay in the electrical path, and this, in the case of an asynchronous induction motor, gives the outof-phase feed to the start winding. Read the rest of this entry »
Most labour-saving household appliances contain an electric motor of some description. They are the workhorse of these appliances and most of them are capable of coping with the work loads inflicted upon them. However, some motors, either through poor design or as a result of manufacturers’ cost limitations, are inadequate for the job they are required to do. Adequate or not, at some point it is almost inevitable that they will fail or simply wear out. To delay this, use the appliance with some care and attention, be aware of its limitations and carry out regular inspection and servicing. This will prevent small problems escalating into major ones
Not only do the sizes of motors vary greatly between products, so too do the ways in which they work. To diagnose faults successfully and service or repair appliances, a working knowledge of motors is essential. The following provide a basic introduction to the various types, a description of how they work, the appliances in which each may be found and their particular advantages and drawbacks. Specific problems can be found on individual appliances. Read the rest of this entry »
