This valve assembly is probably the most important component of the gas burner assembly. The valve assembly controls the flow of gas to the main burner from the gas supply line.
Cycling thermostats are bi-metal devices or thermo-discs that are designed to cut the main burner OFF when a pre-determined temperature has been attained in the dryer drum. There is no adjustment of the temperature response of these thermostats. Read the rest of this entry »
An obvious failure symptom is when you select a drying cycle and attempt to start the dryer, but it does not run. To find the cause of the problem, move the dryer out from its position and unplug the power cord.
If line voltage is indicated on the volt/- ohmmeter, check the dryer power cord as possible cause of the problem.
To avoid any incorrect readings when using the volt/ohmmeter, always “zero” the ohmmeter before making continuity checks on components. Read the rest of this entry »
Specific failure symptoms include: 1) Frost build-up on back wall in freezer section of Fridge. 2) Fridge ice maker not making ice. 3) Food not remaining at the desired temperature in both the Fridge and freezer sections.
When the Fridge starts to build up frost in the freezer section, you can assume that something is preventing the Fridge from going into the defrost cycle. You will have to check the components of the defrost circuit. Move the Fridge out from the wall and unplug the Fridge power cord. Check the components in the order listed below. Read the rest of this entry »
Have you ever used an electrical lawn-mower, or seen someone use it? Enough said. Cords on appliances also fray and sometimes a loose connection is the simple result of wear and tear. So somewhere along the line you may have to repair the wiring of an appliance or replace a plug that is no longer working. Read the rest of this entry »
Turn the electricity OFF at the circuit breaker panel. A suspected broken or burned wire(s) can be checked with the volt/ohmmeter. NOTE: A broken or burned wire(s) that connects to dishwasher components will cause it to not fill with water because electricity is not capable of reaching the water inlet valve. Set the volt/ohmmeter on the RX-1 scale. Connect one probe from the volt/ohmmeter to the terminal of the wire to be checked. Trace the wire to the component that it connects to. Remove the wire from the component terminal. Attach this wire to the remaining probe of the volt/ohmmeter. The volt/ohmmeter should show full scale deflection or 0 ohms. This would indicate that the wire is not defective. If you do not get a reading, the wire is defective and it will have to be repaired or replaced. Read the rest of this entry »
The term ‘harness‘ is used for all of the wires that connect the various components within an appliance. In large appliances they are usually bound or fastened ‘together in bunches to keep the wiring neat and safely anchored. Smaller appliances, however, may sacrifice neatness for safety and route the wiring to avoid contact with heat or sharp edges. The correct positioning of wiring also contributes to the double insulation of an appliance, so no alterations whatsoever should be made to the routing or position of the wiring in double insulated appliances.
When you first take a look at it, the harness may seem like a jumble of wires thrown together, but if you take the time to inspect it, you will find that each wire is colour-coded or numbered either on the wire itself or on the connector at each end. This allows the engineer to follow the wire through the appliance easily. With a little practice, any wiring or coding can be easily followed. Read the rest of this entry »
Throughout this post, references are made to meters and their use in continuity testing of individual parts of the appliances and their connecting wires. All testing and checking for ‘open’ (not allowing for current flow) or `closed’ circuit (allowing current to flow) must be carried out using a battery-powered multimeter or test meter. Testing should never be carried out on live items under any circumstances. Appliances must be disconnected from the mains supply. Read the rest of this entry »
